ChamSys MagicQ Manual de usuario descargar pdf (Pagina 120)

MagicQ Software Change Log 107 / 110

Chapter 70

SnakeSys Firmware Release Notes (B4, R4, T2)

70.1 Version V213

70.1.1 All Products (Improve Policy For Save Of Settings)

Reduced the required time that the user needed to wait for units to save their Net-Manager DMX port settings to ﬂash memory

from 30 seconds to 15 seconds.

Network IP and Subnet-Mask settings that are adjusted from the Net-Manager are now saved to ﬂash memory immediately.

Synchronisation settings were not previously saved, they are now saved immediately to ﬂash after adjustment via the Net-

Manager.

Fixed a bug which caused a longer delay than expected before settings were written to ﬂash memory.

70.2 Version V212

70.2.1 SnakeSys B4

Fixed issue when using Art-Net and ACN subnets 3-0 and above which would cause the DMX packet to be reduced to less than

the full 512 values. This potentially affects all versions V200 to V211 but was most noticeable in V210 and V211.

The above issue would also cause the DMX framing timings to be erroneously adjusted from the defaults when using Art-Net

and ACN start universe above universe 0-0 up to universe 2-15. The DMX output was within spec but could be slower than

expected. In Art-Net and ACN mode the subnet and universe selection were incorrectly being used to used to apply the timing

settings from the buffer mode (as per the rear panel legend).

Fixed break interrupt issue with DMX input which was introduced in V211.

Changed operation of DMX in LED to work like the other products.

70.3 Version V211

70.3.1 SnakeSys T2 Version 2

Added support for T2 Version 2 with DMX input option.

Added PCB version dependent menu items.

1 2 ... 115 116 117 118 119 120 121 122 123

Sin comentarios

ChamSys MagicQ Manual de usuario Pagina 120